Diode LED

Linear LED looks simple: stick the tape in, power it up. Then the far end of the cove is dimmer than the near end, the dimmer buzzes, or a run fails a year later. That’s rarely the tape. It’s the system around it.

Where tape light jobs go wrong

• Voltage drop on long runs, which shows up as uneven brightness.
• A driver that doesn’t match the load or the dimming method.
• No channel or diffuser, so heat builds up and the light looks spotty.
• Dimmer compatibility that nobody checked until the punch list.

One system, from the same manufacturer

Diode LED describes itself as “America’s largest provider of low-voltage linear lighting solutions,” and its line covers every piece of the run:

• Linear LED lighting: tape and strip lights, plus diffused, flexible light such as LINAIRE® Flex and compact grazers like GRAZE X™.
• Mounting channels and accessories.
• Power supplies, including the OMNIDRIVE® 3 dimmable driver.
• Dimmers and controllers for linear LED systems.
• LED fixtures, including factory-finished lighting from Diode LED’s facility in Reno, Nevada.

The resources that prevent the callback

Diode LED publishes the documents you need to get a run right before it’s installed: IES files, LM-79 reports, specification sheets, install guides, voltage drop charts and compatibility lists. Its project support team can also help plan the job. Start at diodeled.com.

Product information is from Diode LED (diodeled.com) as of October 2026. LINAIRE, GRAZE X and OMNIDRIVE are trademarks of their owner.